Hello Guest it is April 12, 2024, 11:16:16 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - ozzey

Pages: « 1 2 3 4 5
41
General Mach Discussion / wizzards not working
« on: February 26, 2014, 02:56:56 AM »
hi im haveing problems with wizzards not working thay did work now dont i tryed to cut circle it turned in to a slot and sum say no licence do i have to buy a  licence ?? for them

42
General Mach Discussion / Re: Ref all axis, and soft limits
« on: February 25, 2014, 03:52:29 PM »
i think you anserd my quesgen when i go for coffey i turn of power to stepper drives i come back turn them on again it must move a bit

43
General Mach Discussion / Re: in accurate x/y axes
« on: February 25, 2014, 03:08:55 PM »
hi again its all from china ball screews brack out bord drives it works grait but not acurate its all keyed on the coupleings so it cant slip it is very fast in on 2500 hz accel is 513.08 and velocty is 3105 Gs what that i dont know 0.52322 next to Gs is step puls 1-5 thats on 0 dir puls 0-5 thats on 0

44
General Mach Discussion / in accurate x/y axes
« on: February 25, 2014, 08:07:13 AM »
hi my x/y axes isnot concistent i have a hole patten with 7 holes every time i run the program it changes slitey any idears maybe step dir in motor tuneing 0/5

45
hi i hate typing i will tel you my trubles latter if i cant work them out

Pages: « 1 2 3 4 5