Hello Guest it is April 12, 2024, 11:29:59 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - ozzey

Pages: « 1 2 3 4 5 »
31
General Mach Discussion / 1 out of 3 axis work
« on: January 07, 2015, 05:33:52 AM »
i tryed my back up computer y axis work x and z don,t all worked good on my 1 st computer tryed reinstall mack 3 no good but if i chack max nc -10 wave drive i can get movement push x+ 2 axis move so the PC knows its there tryed testing parallel port from youtube looks ok 3.3 v on pins 2-9   any help would be good thanks

32
General Mach Discussion / Re: new lathe construction
« on: December 27, 2014, 04:54:09 PM »
thanks rich i will read it

33
General Mach Discussion / new lathe construction
« on: December 27, 2014, 04:21:38 AM »
i am retro fitting my old lathe with stepper motors driver and breakout board all from china (work grate on my mill )  what do need to synchronize the spindle to  the feed to cut a thread sum  thing must tell the feed when to engage when the spindle is in right place

34
General Mach Discussion / Re: missed stepps
« on: May 03, 2014, 04:42:56 PM »
what do the the settings 0/5 ajust why wil i ajust it i have it on 0 i cant find it in manual

35
General Mach Discussion / missed stepps
« on: May 03, 2014, 07:56:57 AM »
can anyone tel me what this dose and how it works im geting missed stepps i think

36
General Mach Discussion / Re: wizzards not working
« on: February 26, 2014, 06:36:01 PM »
ok found it

37
General Mach Discussion / Re: wizzards not working
« on: February 26, 2014, 06:32:41 PM »
ok i can find that licence on web site give me a link please

38
General Mach Discussion / Re: wizzards not working
« on: February 26, 2014, 06:21:46 PM »
most of nfs wizards say no licence copy cat is one

39
General Mach Discussion / Re: wizzards not working
« on: February 26, 2014, 04:57:00 PM »
i have license for mill wizard [ witch i can save or find it after i save it ]its the wizards in mack 3  and no it didnt display  a tool parth

40
General Mach Discussion / Re: wizzards not working
« on: February 26, 2014, 03:24:14 PM »
i have got my license for mack3  it the wizards in mack3 im haveing truble with

Pages: « 1 2 3 4 5 »