Hello Guest it is April 12, 2024, 11:53:58 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - ozzey

Pages: « 1 2 3 4 5 »
11
General Mach Discussion / Re: mxl files
« on: March 08, 2017, 03:12:52 AM »
i was lucky i had a cloned hard drive and xml files on usb drive thanks i will try it tomorow

12
General Mach Discussion / Re: mxl files
« on: March 07, 2017, 09:40:13 PM »
opps xml files

13
General Mach Discussion / mxl files
« on: March 07, 2017, 09:39:26 PM »
can any one tel me how to get old mxl files into a new comuter for mack 3 (the old hard drive stoped working }

14
thank  you i will fix it

15
i am geting error radius to end of ark differs from radius to start if i restart mack 3 it works again sum thing is turning it off any idear what it could be

16
General Mach Discussion / Re: smooth stepper
« on: March 17, 2016, 07:56:23 AM »
im just useing a cheap Chinese breakout board $ 7.50 it works good   but the old PCs  are getting hard to get and unreliable would like to get a new PC

17
General Mach Discussion / Re: smooth stepper
« on: March 17, 2016, 05:11:34 AM »
thanks thats a big help

18
General Mach Discussion / Re: smooth stepper
« on: March 16, 2016, 09:17:12 PM »
if i was to go smooth stepper i could use more than one breakout bored for auto tool change and other stuff 

19
General Mach Discussion / Re: smooth stepper
« on: March 16, 2016, 07:10:04 AM »
as i can see smooth stepper convert your parallel port BOB to  Ethernet on my PC is the write or wrong ?

20
General Mach Discussion / Re: smooth stepper
« on: March 16, 2016, 05:29:17 AM »
the more i read the more confused i get

Pages: « 1 2 3 4 5 »