Messages

21

Mach4 General Discussion / Will D2nc integrate with Mach 4?

« on: September 22, 2018, 08:41:58 AM »

I'm considering upgrading to Mach 4. I can't find information on integrating D2nc with Mach 4. Anyone have an answer?

Thanks...…..gldfshrdr

22

General Mach Discussion / Re: Microsoft Windows 10

« on: February 04, 2016, 06:38:22 PM »

Thanks Tweakie!

23

General Mach Discussion / Microsoft Windows 10

« on: February 04, 2016, 08:02:39 AM »

With Microsoft all but forcing consumers to load Windows 10, will Mach3 run on it?  Has anyone tried running under Windows 10?

Thanks........dt

24

General Mach Discussion / Re: Mulitipass button

« on: November 23, 2014, 08:43:54 PM »

The Multipass wizard works great. The progress screen never showed any progress. But when I checked the file it was there, loaded and ran the simulation just fine.

Thanks......gldfshrdr

25

General Mach Discussion / Re: Mulitipass button

« on: November 23, 2014, 07:46:54 PM »

I do have F-engrave that converts bitmaps to G code. I did not use it in this case. I'm not sure it will allow multipass but I haven't tried it either.

Thanks   .....gldfshrdr

26

General Mach Discussion / Re: Mulitipass button

« on: November 23, 2014, 02:54:18 PM »

Thanks. This should be fun to figure out.

27

General Mach Discussion / Mulitipass button

« on: November 23, 2014, 02:22:22 PM »

Hello, it's me again...
While watching the tutorials I see a Multipass button that doesn't show up in the Program run screen. Am I missing some thing or has this been taken out?
 I finally figure my CAD out and have designed a project that need the multipass option.

Thanks.........gldfshrdr

28

G-Code, CAD, and CAM discussions / Re: newbie....bitmap, jpg to Gcode?

« on: November 06, 2014, 08:03:01 AM »

Thanks again!

29

G-Code, CAD, and CAM discussions / Re: newbie....bitmap, jpg to Gcode?

« on: November 05, 2014, 11:05:55 PM »

As far as I can tell, it works great! Thank you Tweakie! Now lets see what else it will do.

Thanks..........gldfshrdr

30

G-Code, CAD, and CAM discussions / Re: newbie....bitmap, jpg to Gcode?

« on: November 05, 2014, 04:24:45 PM »

Thanks! I'll try it when I get home tonight.

thanks..........gldfshrdr