Topics

11

General Mach Discussion / Jog Speed in Incremental Move

« on: October 05, 2007, 10:37:33 AM »

 ;)Hi
I am puzzled I use my shuttle  and when I set say an incremntal jog, the speed is really slow BUT sometimes it speeds up I dont seem to be able to find how to set this up properly can anyone give me some advise pleas. I find it frustrating that one time the hog speed is acceptable then the next it is really slow (again only in incremental movements) HELP

12

General Mach Discussion / Edge Cam & Mack 3

« on: August 02, 2007, 02:40:02 PM »

 ???Can anyone help me I am looking for a post for edgecam that will mork with mach3. I was told Fanuc 6 or Fanuc 11 would work. does Anyone know where I can get these. Any help aprreciated.

13

General Mach Discussion / Dohin Partmaster & Mach3

« on: July 10, 2007, 03:47:07 PM »

Hi everyone, this is about mach 3 and partmaster, having trouble with partmaster outputting g code for example if I draw a square and creat an approach and run (tear drop) off creat the g code mach portrays the tool path with huge circles on every corner of the square and the approach and run off are the same (tear drop type approaches) now if I change the post process say to micromill all is fine can anyone help me sort this out ... befor I go demented..

14

General Mach Discussion / Emergency stop not working

« on: May 22, 2007, 01:49:33 PM »

Hi to the the forum as I am new,
been working with mack 3 for a couple of weeks and had my machine setup tht if I hit the emrgeny stop switch on screen,  the z would move to safe height. I set this in config\safe z setup. this used to work but I had a little miss hap(my fault) and when I hit stop nothing happened to the z. any help would be appreciated I am running mach version R2.00.065 hope someone can help.