1511
General Mach Discussion / Re: How do you make a manual tool change then re zero the Z?
« on: July 19, 2016, 02:28:42 PM »
Here is the screen set...
http://www.thecncwoodworker.com/2010.html
Touching off is ok but a plate would be more accurate, simple to make/fit if you have a spare input on your control board.
http://www.thecncwoodworker.com/2010.html
Touching off is ok but a plate would be more accurate, simple to make/fit if you have a spare input on your control board.