This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Filename | Downloads | Message | Posted |
---|---|---|---|
65mm Square Circledxf.tap | 245 | Re: THC setting up assistance... | April 14, 2014, 03:00:13 AM |
Screen Shot 2018-02-02 at 10.52.22.png | 243 | Re: Bridgeport Knee Mill Conversion? | February 02, 2018, 05:58:14 AM |
IMG_20180331_104242_resized_20180331_031146250.jpg | 241 | Re: Bridgeport Knee Mill Conversion? | March 31, 2018, 10:38:50 AM |
Screen Shot 2018-02-02 at 10.52.35.png | 238 | Re: Bridgeport Knee Mill Conversion? | February 02, 2018, 05:58:14 AM |
DaveNewMill.xml | 238 | Re: Bridgeport Knee Mill Conversion? | May 24, 2016, 06:01:10 AM |
Bottom Plate setup 1.tap | 231 | Re: Work in a different quadrant? | September 01, 2016, 02:55:22 PM |
daves plasma m3.m1s | 228 | Re: 1st pierce is longer... | August 15, 2014, 04:15:19 AM |
T-Rex Test - 3mm plate 2.tap | 226 | Re: Stop CV issues... | September 13, 2015, 04:42:57 PM |
IMG_20190503_110023_resized_20190503_110151676.jpg | 224 | Re: Mill or Turn? | May 11, 2019, 08:15:30 AM |
1500rpm copy.png | 214 | Re: Mill or Turn? | May 26, 2019, 04:27:07 AM |