Messages

11

General Mach Discussion / Re: Spindle Lock Error G76 Thread Cycle

« on: February 10, 2014, 05:18:43 PM »

Think I need a coffee now to keep going here
Thank you again,
LP

12

General Mach Discussion / Re: Spindle Lock Error G76 Thread Cycle

« on: February 10, 2014, 05:16:54 PM »

 
Try These

13

General Mach Discussion / Re: Spindle Lock Error G76 Thread Cycle

« on: February 10, 2014, 05:07:36 PM »

Oh, ok I try again!
Just a minute...

14

General Mach Discussion / Re: Spindle Lock Error G76 Thread Cycle

« on: February 10, 2014, 05:06:25 PM »

Run for a few passes then hit Cycle Stop.
Enclosed...

15

General Mach Discussion / Re: Spindle Lock Error G76 Thread Cycle

« on: February 10, 2014, 05:03:01 PM »

Just creating a new one!

16

General Mach Discussion / Re: Spindle Lock Error G76 Thread Cycle

« on: February 10, 2014, 05:02:30 PM »

Hang on the Error file in empty!

17

General Mach Discussion / Re: Spindle Lock Error G76 Thread Cycle

« on: February 10, 2014, 04:58:19 PM »

Hi Hood,
Yep, date is set correctly , I am in the UK!  It is 9:47pm.

Just seen that the Mach3 version on PC1 is version 3.00 where the version on PC2 is 3.044.066, I will try to install the olders version on PC2 and see if this error still happens.  I do have two Mach3 Licences!

Enclosed:
The last run of thread TEST 2_LP1.txt
produced the last errors_LP1.txt
using the Mach3Turn_LP1.xml

Thank you.
I'm off for a cup tea now
I will bae back on line tomorrow...
LP

18

General Mach Discussion / Re: Parallel Port Address

« on: February 10, 2014, 03:42:24 PM »

As it doesnt sound like a port address, not sure what controller you are using but check out the following:
Must have at least one axis is set correctly on the Step and Dir don't forget the port setting for each.
Check:
The EStop is on the correct pin and port
The Card Enable is on the correct pin and port

The best way is to disable the Estop and make sure the card is active by using the jog controls.

What controller or breakout board are you using?

LP

19

General Mach Discussion / Re: Spindle Lock Error G76 Thread Cycle

« on: February 10, 2014, 03:22:31 PM »

Hi Hood,
I have just cheched all plugins are disabled but still producing the same error log, is there anyone who can source this error condition.  As it had a 10-90% duty cyucle on the index slot, I have just made a new index pulse card with a 50% duty cycle, this alo made no difference. 
Regards
Paul

20

General Mach Discussion / Re: Spindle Lock Error G76 Thread Cycle

« on: February 10, 2014, 03:12:59 PM »

The Plugin Control menu has only a Video Window.  This is a new install and I have not applied any plugins as yet.
Do you think it is actuating somehow or by some other means, how can I confirm the plugin is disabled?