Hello Guest it is December 03, 2021, 03:19:46 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - KTM

Pages: « 1 2 3 4 5 6 7 8 9 10 »
11
PoKeys / Re: pokeys and relays
« on: September 09, 2011, 09:59:33 AM »
Port 10

12
General Mach Discussion / Re: Reverse RUN problem in second pass
« on: August 04, 2011, 10:17:03 AM »
Thanks Hood,

I have sent Andrew an e-mail, I will post as soon as I receive his reply.

13
General Mach Discussion / Re: Reverse RUN problem in second pass
« on: August 02, 2011, 04:17:39 AM »
Does anyone have an answer for this? as I am sure many people have unhappy customers and damaged jobs because of this and we need an explanation why we replace an existing controller with a controller (Mach) which makes their life more difficult.

14
General Mach Discussion / Re: "To go" DRO
« on: June 12, 2011, 04:59:24 AM »
 ;D Thanks Hood,
It seems that I have the old OEM code list, I've now downloaded this one - http://www.machsupport.com/forum/index.php/topic,9312.0.html, is this the latest?
Regards Steve

15
General Mach Discussion / "To go" DRO
« on: June 12, 2011, 04:03:57 AM »
Hi all,
I know that there is a button that changes the co-ordinate DRO's to the distance to go, but is there a dedicated DRO that shows the distance to go?
The reason why I ask this is that I wish to switch an output off when the distance to go is less than a certain value with a brain or macro.
Thanks, Steve

16
For the pierce delay try using G4 P99 (G4 is dwell and The P is the dwell time), Then the cycle start will will work to continue to the next line.

17
Post your g-code and XML - Then I will have a look at it.

18
It is quite simple to do this in Mach - Just set your pierce delay at 99 sec and when the plate is heated sufficiently press Cycle start and the code will continue from the next line.

19
Finished Screens / Re: Mach3 2010 Screenset - Now available
« on: February 25, 2011, 12:12:00 AM »
Hi Jerry,

I really like the look of you new screens, but the main problem is the resolution - most new screens are wide screen.
If you were to make a widescreen version, I would definitely buy it.

Regards

Steve

20
G-Code, CAD, and CAM discussions / Re: KeyCreator
« on: July 08, 2010, 10:10:48 AM »
Hi Tron,

Check your I J mode in the general config. menu to correct the circular interpolation errors.

KTM

Pages: « 1 2 3 4 5 6 7 8 9 10 »