1
General Mach Discussion / Re: Help Please - Mach3, Breakout Board or VCarve issue?
« on: December 21, 2013, 05:52:50 PM »
Gerry,
I took your advice, uninstalled completely, rebooted, then reinstalled.
No luck there.
I took the old PC I used to run the machine with and tried running a few tool paths, same thing happened.
It looks like it's going to be in the breakout board.
Do you have any advice on troubleshooting a breakout board?
Nothing appears to be burnt or discolored.
Thanks
I took your advice, uninstalled completely, rebooted, then reinstalled.
No luck there.
I took the old PC I used to run the machine with and tried running a few tool paths, same thing happened.
It looks like it's going to be in the breakout board.
Do you have any advice on troubleshooting a breakout board?
Nothing appears to be burnt or discolored.
Thanks