Guest
Show Posts
21
Video P*r*o*b*i*n*g / Digital probing problem ???
« on: December 19, 2013, 10:36:02 PM »
Hi All
doing some digital probing tests using the mach mill digitizing wizard.I can probe the item with no problem at all.save it to a .txt file pull it up on machcloud and render it ok but it only barley resembles the part I probed. it only looks like it is showing me the tool path it took when it probed the part. lines are not connected. the y tool path direction change are angled z paths are crooked just can not get it to change to a point cloud. like it is all jumbled up. I found a file posted here on a chair seat bottom. it renders perfect.
is there some type of setting in mach mill that I missed. I thought it might be noise on the probe signal ran a lab scope on the signal, nice and clean. about to give up and maybe build a 3D video scanner and see if I can make that work.
Help!! DAS
doing some digital probing tests using the mach mill digitizing wizard.I can probe the item with no problem at all.save it to a .txt file pull it up on machcloud and render it ok but it only barley resembles the part I probed. it only looks like it is showing me the tool path it took when it probed the part. lines are not connected. the y tool path direction change are angled z paths are crooked just can not get it to change to a point cloud. like it is all jumbled up. I found a file posted here on a chair seat bottom. it renders perfect.
is there some type of setting in mach mill that I missed. I thought it might be noise on the probe signal ran a lab scope on the signal, nice and clean. about to give up and maybe build a 3D video scanner and see if I can make that work.
Help!! DAS