Messages

41

General Mach Discussion / Re: Picture not okay....

« on: January 02, 2014, 12:29:24 PM »

Hi,

Thanks For your help so far...

I have a CNC3040 and it runs about 45-60min at one time.

Here is the Gcode http://hangonpuukko.fi/pimu.txt

42

General Mach Discussion / Re: The image gets flipped (mirror)

« on: January 02, 2014, 09:48:27 AM »

Okay...

It's now on a number 1 should it be -1?

Thanx..

43

General Mach Discussion / Picture not okay....

« on: January 02, 2014, 07:59:01 AM »

Hi,
I have a picture 140x70mm and the cnc is starting from the middle, but when it is about 80% left it starts to go of track so it leaves tracks that are not mille...

What can I do??
I'm NEW at this....

Thanks!

Finland

http://www.hangonpuukko.fi/WP_20140102_001.jpg

44

General Mach Discussion / The image gets flipped (mirror)

« on: January 02, 2014, 06:17:07 AM »

Hi,

I'm new at this...
I have a problem with a picture that should be pointed to the left but when the Mach3 has done it's job it is pointing to the right?

Why? Can you tell me exactly how I can make it work right?

Thanks!

Finland

45

General Mach Discussion / Re: Probe? Whats that? cnc3040

« on: December 04, 2013, 02:00:59 AM »

Yeah sorry, I have the cnc3040T

46

General Mach Discussion / Probe? Whats that? cnc3040

« on: December 03, 2013, 12:23:18 PM »

Hi,

I'm new at mach3... Do i need a Prode for cnc3040 and Mach3?
And what is it??


Thanx!!

47

General Mach Discussion / Re: Table is not in level?..... cnc3040

« on: December 01, 2013, 12:26:37 PM »

So I will then put an aluminum disk (something else?) on the table and run off a surface of it so I get it straight. And then leave it there so it will be always right?

Could it be that there is something wrong CNC3040 machine?

48

General Mach Discussion / Re: Mach3 and Vcarve6 CNC3040

« on: December 01, 2013, 12:09:14 PM »

Thanks!

I have some problems to get the spindle http://www.youtube.com/watch?v=57xY94SnlCQ

49

General Mach Discussion / Mach3 and Vcarve6 CNC3040

« on: December 01, 2013, 11:55:47 AM »

Hi,


Is there any "right" settings for Vcarve 6 so it will work okay with Mach3 and a cnc3040?

Settings for Feed Rate and Plunge Rate and so on.....

50

General Mach Discussion / Re: Table is not in level?..... cnc3040

« on: December 01, 2013, 11:40:45 AM »

Ok,

How about the feed rate and plunge rate? Can it have something to do with them? I don't know whats a good setting for vcarve 6....