Messages

31

General Mach Discussion / Re: Picture not okay....

« on: January 05, 2014, 07:22:46 AM »

Hi,

Thanks! Now it is updated but it works about 19sec and then it stops to engrave...

What is wrong or what have I done wrong?

Thanks!

-Thomas

32

General Mach Discussion / Re: Picture not okay....

« on: January 04, 2014, 10:42:30 AM »

Hi,

Thanks! It is Version R1.83.027

33

General Mach Discussion / Re: Picture not okay....

« on: January 04, 2014, 10:21:15 AM »

Hi,

Sorry i'm bad at this English... Can you explain in any other way what you mean?



Thanks!!

34

General Mach Discussion / Re: Picture not okay....

« on: January 04, 2014, 07:15:11 AM »

Hi,

Here it is...

35

General Mach Discussion / Re: Picture not okay....

« on: January 03, 2014, 06:30:40 AM »

Okay,

Now i get hang off it
I will put it here soon.
Thanks!!!

36

General Mach Discussion / Re: what is a xml file!?

« on: January 03, 2014, 06:23:49 AM »

Hi,
Yes but does it come automarically? Must i have it to get the gcode to work?
I have made the picture in vcarve 6 pro and vertical..

Thanks

37

General Mach Discussion / what is a xml file!?

« on: January 03, 2014, 05:58:34 AM »

Hi,
What is a xml file? Do i have to make one file to get the Gcode to work okay??

Thanks!
Finland

38

General Mach Discussion / Re: Picture not okay....

« on: January 03, 2014, 05:55:20 AM »

Hi again.....
I dont find any xml file in the mach3 folder just some mach3mill.xml, mach3turn.xml but not any of thoose i have made?...

Thanks!!

39

General Mach Discussion / Re: Picture not okay....

« on: January 03, 2014, 03:19:33 AM »

Hi,
Sorry im new at this whats xml file?? Where can i get it?
Thanks!!

40

General Mach Discussion / Re: The image gets flipped (mirror)

« on: January 02, 2014, 12:33:24 PM »

Okay!

So Dir LowActive X and Y should be red and then it should work fine?
And i Have a CNC3040 so i need only the X Z Y so it will work fine?

Thanx alot man!