11
General Mach Discussion / Table is not in level?..... cnc3040
« on: December 01, 2013, 07:26:03 AM »
Hi,
I'm new with cnc and now i have a cnc3040. The problem I have is that everything else is working fine but the Z axis is not....
When I'm cutting lets say a piece of wood 200mm x 150mm so on the right side it is much more deeper than on the left side...
Why is it so? I have used all the settings that came with the machine...
Thanx for your help, hope you understand me.
Thomas
Finland
I'm new with cnc and now i have a cnc3040. The problem I have is that everything else is working fine but the Z axis is not....
When I'm cutting lets say a piece of wood 200mm x 150mm so on the right side it is much more deeper than on the left side...
Why is it so? I have used all the settings that came with the machine...
Thanx for your help, hope you understand me.
Thomas
Finland