Hello Guest it is March 28, 2024, 05:08:41 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - SirFinland

Pages: 1 2 3 4 5 6 »
1
Hi,

Thanks....It Was okay for 2 weeks.... What kind of a better board can i look at on Ebay? Name? Sort? So i could get one that works 1-5 years... Not weeks...

Thanks!

Finland

2
Hi,

Yes I Would want to make it all better but when I don't have the wiring diagram for all the boards :( ( Just the on you gave me)

Wich part is it that is broken if it is? so i could get a better on...

And The YOC PW 3024 I made it better ;)

Thanks

3
Hi,

Thanks for the help it helpt me! But now i have a Little problem...

Do you know what to do? The cnc3040 board is okay, and one day I was engraving and after 10 min when it was done so the spindle didn't stop, it keep runnig no difference if the spindle was on or off and the Emergency stop didn't work. So now when I put the Power on so the spindle is Always on and I can't change the speed on it.

What could be wrong?

Thanks!!

4
Hi,

I put my file here. When I start the mach3 I put the wood on to the cnc and the blade to the wood surface and then zero all the X Y Z axises and then start.. But then it will drill strait in to the wood about 8MM

Thanks man!!

5
Hi,

It works now but when I'm trying to do something with the cnc so it will drill straight down about 8mm, but i should only go about 3-4 mm..
But after the first 8mm then it will do the 3-4 mm as it should do.

Why so?

Is it the Board or some settings?

Thanks!!

6
Hi,

The wiring diagram said that it is a 100 ohm resistor but it burnt right away...

Did I something wrong or was it the diagram for this board?

Thanks!

7
Hi,

It didn't work.. I was spinning about 2min and 2000rpm and then it burns again.

thanx

8
Thanks!

I will give it a try and let you know then!

Thanks!

9
Hi,

It is a YOOCNC PW 3618 board and I but a mark on whats burn..

Thanks!

Finland

10
Hi,

I know this is the wrong place but I have to try...

Where can i get the wiring diagram to the board of a CNC 3040?

One compounent is dead...


Thanks!

Pages: 1 2 3 4 5 6 »