Hello Guest it is March 28, 2024, 09:06:49 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - silvermine

Pages: 1
1
General Mach Discussion / New Hermes IS400 Volume
« on: May 19, 2007, 01:18:54 PM »
Does anyone know if I can control a New Hermes IS400 Volume as a 4 Axis CNC machine?  Does the Mach 3 work on this machine?  If so, does anyone have the setup data for it.

Thank you,

Ralph

Pages: 1