1
General Mach Discussion / Mach3 and Gecko540
« on: February 07, 2014, 10:07:30 AM »
Good Morning Everyone!
I'm looking for someone who either has a gecko540 controller configured for Mach3 to run a chinese YOCNC 3040 desktop router,
OR,
someone who can configure a gecko540 controller and cables for me.
After running one project on the provided controller box - it's shot. Immediately called Gecko and IMMEDIATELY realized (with the help of a great tech rep) that I don't have the skill set to configure it.
If anyone can help me with this I'd appreciate it.
Thanks everybody.
Joe
(469)363-0651
I'm looking for someone who either has a gecko540 controller configured for Mach3 to run a chinese YOCNC 3040 desktop router,
OR,
someone who can configure a gecko540 controller and cables for me.
After running one project on the provided controller box - it's shot. Immediately called Gecko and IMMEDIATELY realized (with the help of a great tech rep) that I don't have the skill set to configure it.
If anyone can help me with this I'd appreciate it.
Thanks everybody.
Joe
(469)363-0651