1
General Mach Discussion / Re: Mach3 and Gecko540
« on: February 27, 2014, 03:46:55 PM »
Hey Fastest1 and Jeff,
The new Gecko controller is in.
Can I tie this power source in directly?
and
I've bought pre-wired cables - what wires on the new cables should be attached to which coming out of the motor?
Joe
The new Gecko controller is in.
Can I tie this power source in directly?
and
I've bought pre-wired cables - what wires on the new cables should be attached to which coming out of the motor?
Joe