1
General Mach Discussion / Re: my z axis going out of balance
« on: November 03, 2013, 07:18:37 PM »
hi there
thank you very much for helping me
i think that may table or the acrylic plastic have a bump in the middle when i am holding the material width the holder i notice that by putting a piece of plywood (smooth surface) take the z axis down to 0 and travel it manually (Y axis) and you see that at the start of the material its not touching the material but starting the middle (approximately ) the drill bit start touching the matirial and make a straight line (the spindle is off)
do you have any ideas on how to make the surface straight and lineup
again thank you very much
thank you very much for helping me
i think that may table or the acrylic plastic have a bump in the middle when i am holding the material width the holder i notice that by putting a piece of plywood (smooth surface) take the z axis down to 0 and travel it manually (Y axis) and you see that at the start of the material its not touching the material but starting the middle (approximately ) the drill bit start touching the matirial and make a straight line (the spindle is off)
do you have any ideas on how to make the surface straight and lineup
again thank you very much