Messages

61

General Mach Discussion / Re: MR-J2S-A and Mach 3

« on: October 31, 2013, 01:03:38 PM »

HI

I have one other question the  IP-M   not work on Step/Dir it  work with +-10V    and he have feedback   .... If the feedback is used for follow the mouvement CNC   ... IP-M  is it best then IP-S.

If i chose the IP-M   what  pins of driver i need to connect on IP-M...   (in +-10V i can probably use the mode speed) .

I think that is my last question     .



Many Thinks

62

General Mach Discussion / Re: MR-J2S-A and Mach 3

« on: October 31, 2013, 10:00:40 AM »

how i can   connect CSMIO   to my J2S-A drivers   ? If output is 5V  and i need 24V  .

63

General Mach Discussion / Re: MR-J2S-A and Mach 3

« on: October 30, 2013, 10:09:11 PM »

Hi

If CSMIO can output 24V   on step/dir    i think that J2S-A is 24V .

Thinks 

64

General Mach Discussion / Re: MR-J2S-A and Mach 3

« on: October 30, 2013, 02:33:51 PM »

and if i go with CSMIO   ... witch one i can choose ... he have many models    ... the CNC have 2 motors for axis X  (one each side of CNC)    1 motor for axiz X and 1 for axis Z   .

65

General Mach Discussion / Re: MR-J2S-A and Mach 3

« on: October 30, 2013, 02:19:24 PM »

Hi

can you confirme me if J2S-60A   can do step/dir     

thinks

66

General Mach Discussion / Re: MR-J2S-A and Mach 3

« on: October 29, 2013, 05:21:59 PM »

My drivers is MR-J2S-60A    .... i think hi can do step/dir   

https://my.mitsubishi-automation.com/downloads/view/doc_loc/1375/138918.pdf?id=1375&saveAs=0&form_submit=View+now

if you can see page 24     hi can do with parameter 0011   ....   i never set this parameters  ... can you help me    ... or if you have a filet set it directly by PC   will be  good ..

Thinks

67

General Mach Discussion / MR-J2S-A and Mach 3

« on: October 28, 2013, 07:22:02 PM »

Hi

I have motors and drivers Mitsubishi  ... but i am need a help  ...how i can connect this drivers to mach3 ... can you propose me some controllers non very expensive to tray this ...

Thinks