Hello Guest it is March 29, 2024, 08:49:55 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - sdow

Pages: « 1 2 3 4 5 6 7 »
51
General Mach Discussion / Re: MR-J2S-A and Mach 3
« on: November 04, 2013, 04:56:41 PM »
Because  many inputs is 24v or 10v?

52
General Mach Discussion / Re: MR-J2S-A and Mach 3
« on: November 04, 2013, 04:47:23 PM »
if me encoder give 24V   what i can do to connect it  to CSMIO

53
General Mach Discussion / Re: MR-J2S-A and Mach 3
« on: November 04, 2013, 04:33:59 PM »
if you look the page 9      +Z go to -> pulse Z (J2s)  and  - Z go to -> diff.  Z (J2S)  ?

is it right ?
and page 9   http://www.cs-lab.eu/en/upload/pdf/Conectors%20CSMIO-IP-A.pdf

54
General Mach Discussion / Re: MR-J2S-A and Mach 3
« on: November 04, 2013, 03:55:57 PM »
Hello Hood

I will go probably with IP-A   ... i need a help   ... how i connect the encoder with to CSMIO ...   In CSMIO have  encoder Z  +  and -  ....?

Thinks

55
General Mach Discussion / Re: MR-J2S-A and Mach 3
« on: November 01, 2013, 09:45:43 PM »
Hi hood

I have one question for you My drivers  use 1 phase 230V  but is not connected to Magnetic contactor   is  it normal     ? Can hi work with no Magnetic contactor ?

Thinks

56
General Mach Discussion / Re: MR-J2S-A and Mach 3
« on: October 31, 2013, 06:08:48 PM »
This Topic is not open just for Me and Hood ....other people can answer  for tools tool setter ;)

57
General Mach Discussion / Re: MR-J2S-A and Mach 3
« on: October 31, 2013, 05:20:20 PM »
i think that tool setter is good gadget when you change tools manual   .

58
General Mach Discussion / Re: MR-J2S-A and Mach 3
« on: October 31, 2013, 05:17:54 PM »
i can use function generator tools  to do pulses

59
General Mach Discussion / Re: MR-J2S-A and Mach 3
« on: October 31, 2013, 04:52:11 PM »
Before making my purchase how I can test manually or with a very small electric scheme to turn my engine  for both options Step / dir and analog .... just to make sure that both options works work ...

A final issue which auto-check tools you propose me to buy ...   i see this but is very poor     http://www.ebay.com/itm/CNC-Router-MACH3-Engraving-Machine-Tools-Auto-Check-Instrument-/321113660003
   ... do you know best tools ...

Thinks

60
General Mach Discussion / Re: MR-J2S-A and Mach 3
« on: October 31, 2013, 02:35:36 PM »
Which pins i need to use on my J2S-A   for  IP-A

Pages: « 1 2 3 4 5 6 7 »