Messages

41

General Mach Discussion / Re: MR-J2S-A and Mach 3

« on: November 06, 2013, 05:00:41 PM »

i use the page  :  3-6   and  5-2 to 5-3

42

General Mach Discussion / Re: MR-J2S-A and Mach 3

« on: November 06, 2013, 04:55:17 PM »

yes

43

General Mach Discussion / Re: MR-J2S-A and Mach 3

« on: November 06, 2013, 01:23:20 PM »

i put the parameter no.43 -> 0111   no.44 -> 0222 no.45-> 0665 no.46->0770 no.47->0883 no.48-> 0994

battery:  + to VC and - to LG

44

General Mach Discussion / Re: MR-J2S-A and Mach 3

« on: November 06, 2013, 08:44:29 AM »

yes i connect 15  16 17 to 10   ...but not set the parameters  i can not find this   ?  But, when i connect pin 5 to 10 ...i have torque ?

45

General Mach Discussion / Re: MR-J2S-A and Mach 3

« on: November 05, 2013, 11:44:51 PM »

Hi Hood

When i put directly 3v to VC  ... my motor not run ? 

46

General Mach Discussion / Re: MR-J2S-A and Mach 3

« on: November 05, 2013, 06:54:09 PM »

http://www.youtube.com/watch?v=VwyZgTnSCdw

47

General Mach Discussion / Re: MR-J2S-A and Mach 3

« on: November 05, 2013, 06:34:15 PM »

LG is it = to GND

48

General Mach Discussion / Re: MR-J2S-A and Mach 3

« on: November 05, 2013, 06:21:06 PM »

Hi Hood

When i connect  my drive and motor to 230V  my motor not have  any power  is very easy to turn it by my hand ... When i turn it  by my hand i can  see the info . of encoders . Is it normal .

Now can i do this ...

49

General Mach Discussion / Re: MR-J2S-A and Mach 3

« on: November 04, 2013, 06:34:26 PM »

HI Hood


Can i ask you one other question can you make me one picture  how connect the output  +-10V (  CSMIO ) to driver .

Tomorrow i test all and buy my CSMIO .

Thinks

50

General Mach Discussion / Re: MR-J2S-A and Mach 3

« on: November 04, 2013, 05:55:50 PM »

for  a CNC 3 axis  what you prefer IP-A or IP-S  and why ?   I do not which choose ?