Messages

11

CS-Lab / Re: tuning motors

« on: June 22, 2014, 08:58:45 AM »

what i need to click on keyboard to move it

12

CS-Lab / Re: tuning motors

« on: June 22, 2014, 12:50:04 AM »

Hi hood

I +- finished my CNC  ... but i have a problems with a limit switches ..... when the cmc go and touch the limit switch  ...the cmc stop ... and i can not run it in opposite side  ....i need to remove my limit switch  (manually ) to move my cnc .

thanks

13

CS-Lab / Re: tuning motors

« on: June 18, 2014, 06:38:51 PM »

Hi hood

I tuned my motor Y  is very good .... but when i add a slave motor Y  .... i really have problem to get same speed ?   can you help  ... my motor 1 is stopped and motor 2  go  5 rpm front ...5 rpm rear ......

thanks

14

CS-Lab / Re: tuning motors

« on: June 09, 2014, 02:15:25 PM »

i will probably use the relays    because my SON (enable ) need to connect to LG (GND) of my drivers .... i will use 4 relays each for one drive connected in parallel  to IO3 of csmio

15

CS-Lab / Re: tuning motors

« on: June 09, 2014, 01:35:14 PM »

Can you give me the picture where i can find the configuration for enable the drivers ....exemple i would connect all my drivers to I/O 3 on csmio

16

CS-Lab / Re: tuning motors

« on: June 08, 2014, 06:59:02 PM »

yes my drive have enable where i need to connect it on cs-mio

17

CS-Lab / Re: tuning motors

« on: June 07, 2014, 03:24:31 PM »

or when i close  mach3 my motor start to run +-40rmp/min

18

CS-Lab / Re: tuning motors

« on: June 07, 2014, 01:10:52 PM »

hu hood

my pid is good when Stop button is not activated my motor mont run ... but when i click on Stop ... the motor start to run +-40rmp/min ?

19

CS-Lab / tuning motors

« on: June 06, 2014, 11:47:51 AM »

Hi

When connected my drive to cs-mio/ip-a  .... my motor started to run .... why ? Can you help me ?   When i try to click on auto tuning PID  ... i have error ...ePID....

Thanks

20

CS-Lab / Re: how to wire PNOZ X7 with drivers MR-J2S-60A and CSMIO-IP-A

« on: April 19, 2014, 03:49:41 PM »

i see in this picture  we can connect many faults to the in CS-MIO-A ... i not see where i need to connect it on the port inputs 0-11 and how configure that  ....if is 0 on input 1 ,2 or 3  ....all motors need to stop