Messages

11

General Mach Discussion / Re: 3D Aspire to Mach3.....

« on: September 08, 2015, 11:27:08 AM »

Okay here it is

12

General Mach Discussion / Re: 3D Aspire to Mach3.....

« on: September 08, 2015, 11:22:04 AM »

How do I get it here? It says it is to big file

13

General Mach Discussion / Re: 3D Aspire to Mach3.....

« on: September 08, 2015, 11:18:59 AM »

Hi,

Download it from here

www.hangonpuukko.fi/kim.crv3d

And now when I was tring the CNC so I have everything in MM, and it should cut 1mm but it cuts about 3,4mm deep hole at once... Is it confuse with MM and Inch?

14

General Mach Discussion / Re: 3D Aspire to Mach3.....

« on: September 08, 2015, 10:41:00 AM »

Hi,

I have no idea! What shoild i do? The CNC does it with old projects to...

I hade to install Mach3 again on my computer and mayby I have some wrong settings there... Do you know where I could get the right settings??

Thanks!

15

General Mach Discussion / Re: Mach3 to Windows7 32

« on: September 08, 2015, 10:11:11 AM »

Hi,

I'm new with this but so much I know that I have exactly the same settings on the both computers.

XP works okay and Win 7 not.

Thanks!

16

General Mach Discussion / Re: 3D Aspire to Mach3.....

« on: September 08, 2015, 10:07:57 AM »

Here is the Aspire code I have.

17

General Mach Discussion / Re: 3D Aspire to Mach3.....

« on: September 08, 2015, 10:00:23 AM »

Hi,

Could it be this... The wood that i'm cutting is 18mm but i have under it 2mm wood so I would not cut the table....

Thanks!

18

Share Your GCode / Soft jig Lure G Code??

« on: September 08, 2015, 04:14:34 AM »

Hi,

Do any one have a Soft jig Lure Gcode that you would be willing to give or sell?

Let me know!!

Thanks!

Thomas

19

General Mach Discussion / Mach3 to Windows7 32

« on: September 08, 2015, 04:10:53 AM »

Hi,

I have tried to put Mach3 to Win7 but i get this all the time: Limit Switsh Triggered...

Why? I have the same settings that i have on WinXP

Thanks!

Thomas

20

General Mach Discussion / 3D Aspire to Mach3.....

« on: September 08, 2015, 04:06:04 AM »

Hi,

When I make a 3D text with Aspire 4.0 to Mach3, it looks okay on Aspire but when i start it on Mach3 and it should start at the top off the wood (cutting at 1mm) but it cuts straith in to the wood about 10 - 20mm Why??

Thanks!!

Thomas