Hello Guest it is March 28, 2024, 07:25:24 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - jokernippe

Pages: 1 2 3 »
1
General Mach Discussion / Re: STEPCRAFT 840 to Mach3... Help
« on: March 17, 2018, 01:51:10 PM »
Aspire

2
General Mach Discussion / Re: STEPCRAFT 840 to Mach3... Help
« on: March 17, 2018, 12:41:07 PM »
Hi,

I have Mach3

3
General Mach Discussion / STEPCRAFT 840 to Mach3... Help
« on: March 17, 2018, 10:39:06 AM »
Hi,

I have bought Stepcraft 840 and I can't get it to work with Mach3...

When I'm trying to make a 100 x 100mm square it won't do it like it should do. It will be like a Signature....

What should I do or what am I doing wrong?

Thanks!

Thomas
Finland

4
General Mach Discussion / Re: 3D Aspire to Mach3.....
« on: September 08, 2015, 12:02:41 PM »
What should I do now?


5
General Mach Discussion / Re: 3D Aspire to Mach3.....
« on: September 08, 2015, 11:54:58 AM »
Aspire 4.015 Where can I see if it is 32 or 64 bit?

Should it be 32?

6
General Mach Discussion / Re: 3D Aspire to Mach3.....
« on: September 08, 2015, 11:50:23 AM »
This One?

7
General Mach Discussion / Re: 3D Aspire to Mach3.....
« on: September 08, 2015, 11:43:09 AM »
Now I just made a box 50 x 50mm and made a pocket toolpath. 2mm deep and it cuts 0.5mm.

That one works okay. But when I make something bigger it dosen't work...

8
General Mach Discussion / Right settings form CNC3040??
« on: September 08, 2015, 11:41:08 AM »
Hi,

I'm having problem with My settings on Mach3 for my CNC3040...

What is the right settings and what all settings most I have to get it to work right??

Thanks

9
General Mach Discussion / Re: 3D Aspire to Mach3.....
« on: September 08, 2015, 11:34:31 AM »
I have a CNC3040 and when I start Mach3 so It will automaticlly start to drill a 4mm hole. It should make a 1mm hole...


10
General Mach Discussion / Re: 3D Aspire to Mach3.....
« on: September 08, 2015, 11:30:35 AM »
What could be wrong??

Pages: 1 2 3 »