11
General Mach Discussion / Bunch of circles in my preview window?
« on: December 25, 2013, 06:53:28 PM »
Not sure what to call it but if you look at the attached image it is the pink lines in the window.
Run it thru the Discriminator CNC Editor it runs good(to me since I am still learning)
I think I might have something set wrong in Mach3.
Anyone have any ideas on what is causing the pink areas?
Run it thru the Discriminator CNC Editor it runs good(to me since I am still learning)
I think I might have something set wrong in Mach3.
Anyone have any ideas on what is causing the pink areas?