Hello Guest it is March 28, 2024, 07:04:11 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - randoma

Pages: 1
1
I recently moved my Comet 10x50 Milling Machine. In the process I had to disassemble everything and then re-assemble it. My PC is a pretty old Pentium III running WinXP - I think I originally put it together over 10 years ago.. Anyway, the last time I ran the machine was about 3 years ago (before the move) and everything worked then.

I'm using GeckoDrive G320 servos and they are holding position as I'd expect them to.

If I startup Mach3, everything looks fine, but when I enter G01 X1 F5, Mach appears to move (the onscreen DRO changes and the red line in the toolpath display shows up) but the motor does not do anything.

Also, every time I boot up the machine I get a WinXP error that says that "WinXP has recovered from a serious error" but does not tell me what the error is.

So... Before I reinstall Windows (I don't think I even have a copy of WinXP anymore), is there some easy way to tell if Mach is actually sending signals out of the parallel port (indicating that I have a cabling problem and not a PC problem)?

Any advice would be greatly appreciated!

2
Competitions / Re: ******Guess and win a G100 Grex******
« on: May 15, 2007, 11:44:29 AM »
Assuming a 50% duty cycle and a full 8 hour day, 2,736,000!

Pages: 1