1
General Mach Discussion / Is there a wizard to skim a wooden work bed level ?
« on: November 17, 2014, 03:54:21 PM »
I want to secure a piece of ply wood to my machine work bed and them clamp workpiece to that.
I need to skim the plywood level, or at least a 250x250 mm square of it.
Is there a mach 3 Wizard to do this ?
if not I would willingly pay someone to write some gcode to do it ..say 1mm Z
Thanks
Ror
I need to skim the plywood level, or at least a 250x250 mm square of it.
Is there a mach 3 Wizard to do this ?
if not I would willingly pay someone to write some gcode to do it ..say 1mm Z
Thanks
Ror