1
General Mach Discussion / Binding when homing at 100% speed
« on: August 28, 2013, 06:47:36 AM »
Hi,
since I set up my mill I have this problem that X,Y and Z axis will bind when going for reference at speeds higher then 40% of max speed.
I do not have problems with max speed (1200mm/min) and acc (700mm/sec^2) when jogging on the BF20L, but when homing this problem occurs.
Is there a solution to this?
Thanks!
since I set up my mill I have this problem that X,Y and Z axis will bind when going for reference at speeds higher then 40% of max speed.
I do not have problems with max speed (1200mm/min) and acc (700mm/sec^2) when jogging on the BF20L, but when homing this problem occurs.
Is there a solution to this?
Thanks!