Hello Guest it is November 22, 2019, 02:24:32 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - h8ers_suck

Pages: « 1 2
11
General Mach Discussion / axis doesn't move after upgrade
« on: August 24, 2013, 02:47:55 PM »
I am very new to mach 3 and purchased a bridgeport with an old unlicensed version of mach 3.  It was working fine but I needed a full version of mach 3, so I purchased one and updated mach 3 as well.  Now I can't get anything to work; can someone please give me some advise.

Pages: « 1 2