1
General Mach Discussion / Re: MACH 3
« on: February 16, 2019, 10:40:01 PM »
Gday,
Thanks Gerry.
I have tried reversing each axis but that does not fix it , infact it then would not line up with the limit switches.
The axis work correctly I think ie when I operate the X axis the X axis operates and the same with the Y axis.
They home correctly its just the cutout is wrong .
Trevor
Thanks Gerry.
I have tried reversing each axis but that does not fix it , infact it then would not line up with the limit switches.
The axis work correctly I think ie when I operate the X axis the X axis operates and the same with the Y axis.
They home correctly its just the cutout is wrong .
Trevor