1
General Mach Discussion / Mach3 problem with Huanyang VFD + 1.5Kw Water cooled spindle
« on: August 06, 2013, 09:19:07 AM »
i buyed the Huanyang VFD + 1.5Kw Water cooled spindle ;
I have configured the driver for the adapter and install the plugin that i found here http://royaumedeole.fr/informatique/...-huanyang-vfd/ connected with usb cable RS485-USB to PC ;
infact when i open the Mach3 Version R3.043.066 the software confirm with a pop-up that "Configuration ok - spindle speed 3000 rpm at 50 Hrz" .
When i press F5 to start the spindle there is a click from the VFD and the estop of Mach3 starts flashing.
Huanyang VFD and 1.5Kw Water cooled spindle are OK ; infact if I leave in VFD Pid 001 and 002 to zero ( manual control ) the spindle strarts adn stops withou problem
but if i set in VFD Pid 001 and 002 to two ( remote control with Mac3 ) the spindle don't start.
can someone hel me to solve the problem ?
thanks
I have configured the driver for the adapter and install the plugin that i found here http://royaumedeole.fr/informatique/...-huanyang-vfd/ connected with usb cable RS485-USB to PC ;
infact when i open the Mach3 Version R3.043.066 the software confirm with a pop-up that "Configuration ok - spindle speed 3000 rpm at 50 Hrz" .
When i press F5 to start the spindle there is a click from the VFD and the estop of Mach3 starts flashing.
Huanyang VFD and 1.5Kw Water cooled spindle are OK ; infact if I leave in VFD Pid 001 and 002 to zero ( manual control ) the spindle strarts adn stops withou problem
but if i set in VFD Pid 001 and 002 to two ( remote control with Mac3 ) the spindle don't start.
can someone hel me to solve the problem ?
thanks