11
General Mach Discussion / Re: No Y axis movement from G code
« on: July 29, 2013, 05:36:40 PM »
Hi Hood,
It runs fine to the start position and drills both the holes, then moves to start cutting the square and it will run down the x axis but not the y axis. Nothing happens on the y axis at all. Then moves back to the start position.
Thanks Gav
It runs fine to the start position and drills both the holes, then moves to start cutting the square and it will run down the x axis but not the y axis. Nothing happens on the y axis at all. Then moves back to the start position.
Thanks Gav