1
General Mach Discussion / Re: No Y axis movement from G code
« on: July 28, 2013, 02:23:51 PM »
Ok thanks Hood,
The drilling section of the 'test' file is fine but cutting out the square doesn't happen. The 'x' axis moves fine but the 'y' axis doesn't move at all. Although it shows moving on the dro.
Cheers,
Gav
The drilling section of the 'test' file is fine but cutting out the square doesn't happen. The 'x' axis moves fine but the 'y' axis doesn't move at all. Although it shows moving on the dro.
Cheers,
Gav