1
General Mach Discussion / USB set up help?
« on: May 09, 2020, 07:46:23 AM »
Hello,
I had a old C10 board and sold all the components but an still using the old windows XP with mach 3 version R3.043.066. Now i just purchased a USB BOB and looking for the settings. I am still using the old windows XP system. Every time I go to motor turning tab and mess with the settings says ERROR FOUND, Art Code 9991, Attempt recovery. Error triggered . I click yes and nothing, I click No and the program crashes.
Any help would be much appreciated.
I had a old C10 board and sold all the components but an still using the old windows XP with mach 3 version R3.043.066. Now i just purchased a USB BOB and looking for the settings. I am still using the old windows XP system. Every time I go to motor turning tab and mess with the settings says ERROR FOUND, Art Code 9991, Attempt recovery. Error triggered . I click yes and nothing, I click No and the program crashes.
Any help would be much appreciated.