Hello Guest it is December 07, 2021, 10:57:06 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - daibeer

Pages: « 1 2
11
General Mach Discussion / Not working after update
« on: September 14, 2013, 09:34:13 AM »
Hi guys,
I just updated mach3 to the latest version and it's thrown a wobbly.  Basically, I done a 5 inch test cut but it  seems to go through the correct motions but cut approx. 5 mil.  I have been told to check gcode but it seems ok.  Is there anything in the config I need to look at.
regards
Dave
ps.  I am a comparative convert so simple talk would be appreciated.

12
General Mach Discussion / Re: File rotation
« on: July 18, 2013, 05:03:48 AM »
Hi
Good advice methinks
thanks
Dave

13
General Mach Discussion / Re: File rotation
« on: July 18, 2013, 03:47:57 AM »
Hi
Thanks, I just tried that.  Before the alteration, the file is positioned in the top right of the crosshairs, when I alter it to -90 in the MDI tab, it moves it to the bottom right of the crosshairs.  What difference will this make?
regards
Dave

14
General Mach Discussion / Re: File rotation
« on: July 17, 2013, 03:17:01 PM »
Hi
Thanks, I'll look into it.
regards
Dave

15
General Mach Discussion / File rotation
« on: July 17, 2013, 11:43:44 AM »
Hi,
Can anyone tell me how to rotate my file by 90 degrees when it has been loaded into mach3?

16
General Mach Discussion / Re: new to mach3 and K2
« on: July 11, 2013, 03:55:51 PM »
Hi
I thought I would jump in on the HEIZ thread to ask a newbie question so here goes, Where in the configuration tables on M3 do you insert the size of your table? For instance, I have a S-1000 and one of my colleagues has a 400.  In PCNC you input your table size.  Can anyone advise please, also, which is the best M3 PP in Vectric programs, I have been using M3/2 arcs inch. is that the right one?
Thanks
Dave

17
General Mach Discussion / Re: Turn off E-Stop
« on: July 11, 2013, 01:45:55 PM »
Hi
Thanks for that, at the mo, I have it down to 100.
regards
Dave

18
General Mach Discussion / Re: Turn off E-Stop
« on: July 10, 2013, 01:48:25 PM »
Hi all,
Im new to this forum after buying Mach3 transferring from WIN PCNC-USB.  I used the file Donkeyot posted  to configure my Heiz s1000 and got it to work (thanks, I would have never figured it out on my own) but my Reset keeps tripping.  Has anyone had this and got a soulution or suggestions?  Thanks
Dave

Pages: « 1 2