Messages

21

General Mach Discussion / Re: Kernel speed set to high on z axis and will not save calibration.

« on: July 09, 2013, 09:21:50 AM »

Ok Rich I'll look into that, thanks. I did adjust my X axis drive under the table as it was binding. Now that is fixed it works better of course but I can't get it close to cutting a proper pattern since the dimensions are way off. I knew this would involve a lot of learning but not this much!! LOL..
I'll try and get back here to reply.

Andrew

22

General Mach Discussion / Re: Kernel speed set to high on z axis and will not save calibration.

« on: July 08, 2013, 11:06:03 PM »

Did anyone solve this? Mine is doing the same thing. I calibrate and then it sets the new steps/per, but it doesn't even come close when I run a new calibration to check how far it moved. It just keeps coming up short and increasing steps until it maxes out then complains it's too high for 25000 kernel.

What's going on??