1
Share Your GCode / trying to cut a bushing but....
« on: July 09, 2013, 07:50:05 PM »
So i am trying to mill out a 4" circle with a 3" circle inside but i cant write a G code to cut a Full circle. this is what i have.
g0 x0 y0
g01 z-1
g02 x1.5 y0 r-1.5
sure could use a little help here
g0 x0 y0
g01 z-1
g02 x1.5 y0 r-1.5
sure could use a little help here