Hello Guest it is December 06, 2021, 01:11:59 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Børge

Pages: « 1 2 3
21
Thanks Rich, will look into that.

Børge

22
VB and the development of wizards / Multipass Wizard for Mach Turn
« on: June 30, 2013, 03:43:17 PM »
Hi, i am new to Mach3, i have used it for a while and i like it.
But, when turning i would like to have the posibility to have multipasses.
Is there anyway to do this in Mach3 Turn.
i tried to make the G code in mach3 mill, and use the Multipass file converter, but in Mach Turn i get a Wrong Preview of the job. ?
Is there another way to do this

Thanks

Børge

Pages: « 1 2 3