Messages

11

CS-Lab / Re: Soft Limit Problem

« on: January 25, 2014, 05:13:18 AM »

I have found the problem. Fixed and it is working fantastic.
The problem was actually very simple.
In CS-Lab Plugin menu> submenu "Special Functions" > tab "Other" the "Set Axis to "0" on reset" was not enabled.

12

CS-Lab / Re: Soft Limit Problem

« on: January 23, 2014, 03:05:22 PM »

XML File

13

CS-Lab / Re: Soft Limit Problem

« on: January 23, 2014, 03:04:43 PM »

Hood,

Fantastic that it works on your machine, that means there must be a setting wrong on my machine.
Witch Mach3 & CS-Lab Plugin version are you using?

Here is my XML

14

CS-Lab / Re: Soft Limit Problem

« on: January 22, 2014, 05:35:31 AM »

Hood,

Did you try the C-Axis on your machine?
Thanks

15

CS-Lab / Re: Soft Limit Problem

« on: January 18, 2014, 03:04:00 PM »

Yes I have a license, but because I removed Mach3 completely I forgot to put the license back.
But this do not have affect on this problem. Before removing Mach3 I had the same problem I took the Video after new fresh install.

16

CS-Lab / Re: Soft Limit Problem

« on: January 18, 2014, 10:51:08 AM »

Hood,

Disable/Enable the "Rotational Sof Limit" don't do the job, even restarting Mach3 in between.

What I definitely do not understand is why an axis move when in Cont JOG and not in Step Jog or with G-code.
It seem CS-Lab is blocking something.

I am in contact with CS-Lab, any updates I will post.

Here an other video http://youtu.be/GDhxGVzLJgc

17

CS-Lab / Re: Soft Limit Problem

« on: January 18, 2014, 05:58:21 AM »

I have done all the settings.
Referencing the Axis is done + C-Axis. All green lights are ON.
Softlimits are now ON.
Now I do not get the error message, but I am not able to JOG in STEP mode only in Continues mode.

See video for more detail. http://www.youtube.com/watch?v=rScPbOz8PIw

18

CS-Lab / Re: Soft Limit Problem

« on: January 17, 2014, 05:59:55 AM »

I had email contact with CS-Lab
And they say this:

It is about that although the C axis doesn't have the home switch the home diode of C axis must light green so the fault you have showed in a picture won't show up.
It is enough to press  "Ref C" w 'Diagnostic Alt-7"   or improve VB macro of "Ref All Home" (this button does the homing for x, y, z axes and there is no homing for b and c).

They also attached a video, I will try to upload it to youtube later.

It is very clear what is happening, I try this later on the machine and post the feedback.

19

CS-Lab / Re: Soft Limit Problem

« on: January 09, 2014, 02:19:47 PM »

After disable the "Rotational Soft Limit" I installed some old versions until 044.
But still getting this message, I think it is a bug in the CSMIO.

20

CS-Lab / Re: Soft Limit Problem

« on: January 09, 2014, 01:33:00 PM »

Hood,

Disable the soft limits for rotational axis, does not the job still getting the error.