11
General Mach Discussion / struggeling to run a gcode from cambam
« on: June 06, 2013, 09:56:11 PM »
I'm very new to this and still learning, and I am hoping someone can identify what is causing my gcode not to run correctly in mach3.
I made the tool paths in cambam and I must be missing something, I just don't know what...
I attached the gcode in case anyone could take a look at it. I have a feeling it is something simple that I just don't know about...
Thanks!
I made the tool paths in cambam and I must be missing something, I just don't know what...
I attached the gcode in case anyone could take a look at it. I have a feeling it is something simple that I just don't know about...
Thanks!