Hello Guest it is May 29, 2024, 05:37:45 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - JMF

Pages: « 1 2 3 4 5 6 7 »
21
Video P*r*o*b*i*n*g / Re: New 200X Microscope Camera
« on: March 06, 2014, 09:07:24 PM »
I would suggest that you add an Xbox 360 to be used along with the camera.
Have fun .....

RICH

Yes that would be nice, I need to do some reading on adding the Xbox controller, I know nothing about it.

22
Video P*r*o*b*i*n*g / Re: New 200X Microscope Camera
« on: March 04, 2014, 11:29:08 PM »
I have same cameras. What is your plans for the camera, video probe?

Sent from my GT-P3113 using Tapatalk

Yes, I purchased the license for CopyCat and plan to use the camera to probe and also try to use it for parts replication.

23
General Mach Discussion / Re: Mach3 PWM issues
« on: February 28, 2014, 01:02:48 PM »
Thanks, I'll look into it further...

24
General Mach Discussion / Mach3 PWM issues
« on: February 26, 2014, 11:12:43 AM »
I've checked the forums until my head hurt and am not getting anything.

I had my Mach3 setup to run my 2.2KW spindle using the PWM and a G540, it was working fine until recently, now if I check the output voltage that goes to the VFD, it's always ~8.4 volts with a 10v input to the G540, I checked pin 14 on the parallel port with a scope and it's a 25khz signal at 50/50 duty cycle, it does not change at all, it's just a nice square wave, I'm running out of ideas, what happened to Mach3, as I said it was working ?

Any help would be appreciated.

  Thanks,
        John

25
Show"N"Tell ( Your Machines) / Re: My CNC Router
« on: February 21, 2014, 06:37:22 PM »
Thanks, I had a bunch of the LED strips that I wasn't using so I found a good use for them with the machine, I also bought these from Ebay, 80mm LED rings and it fits perfectly under the spindle.


26
Show"N"Tell ( Your Machines) / Re: My CNC Router
« on: February 20, 2014, 06:14:50 PM »
As soon as I get some better pics I'll post some of my projects.

27
Show"N"Tell ( Your Machines) / Re: My CNC Router
« on: February 20, 2014, 06:14:06 PM »
Thanks for the kind words.

28
Show"N"Tell ( Your Machines) / Re: My CNC Router
« on: February 18, 2014, 10:39:43 PM »
Overloaded - Thanks for the kind words.

                   I definitely will post more pics...

29
Show"N"Tell ( Your Machines) / My CNC Router
« on: February 18, 2014, 03:59:43 PM »
Some pics of my CNC Router, just installed the cable drag chain and man did that clean up my wire mess.


30
General Mach Discussion / Re: Checking your CNC for squareness and accuracy
« on: February 17, 2014, 08:25:35 PM »
Very nice work thanks.

It would be awesome if you did a Youtube video on this....

Pages: « 1 2 3 4 5 6 7 »