1
General Mach Discussion / Set up steps on Bridgeport Series II NC
« on: December 31, 2014, 11:20:02 AM »
Need help setting up motor steps on a Bridgeport Series II NC.
I used gecko drives with Mach 3 software using the existing
Superior Step Motors.
To get to run one inch I had to put in 80,000 steps and
the fastest I could get it to run was around 20 inches per minute.
It seems to be microstepping.
Would prefer it to step .001" instead of .0001".
I have set one up before and I used 2000 steps and got 120 ipm.
This one won't take it.
What am I doing wrong.
I used gecko drives with Mach 3 software using the existing
Superior Step Motors.
To get to run one inch I had to put in 80,000 steps and
the fastest I could get it to run was around 20 inches per minute.
It seems to be microstepping.
Would prefer it to step .001" instead of .0001".
I have set one up before and I used 2000 steps and got 120 ipm.
This one won't take it.
What am I doing wrong.