Hello Guest it is June 21, 2021, 01:13:54 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - Rickyg32

Pages: 1
General Mach Discussion / Newbie XBOX controller question (Macros)
« on: May 11, 2013, 05:03:23 PM »
hi out there.
Hope someone has some guidance on a small problem I am having.
Installed the Xbox controller and it works great with one exception. I have assigned two macros for the two buttons and when I push the buttons during operation.
I get a message in Mach3 indicating the macro has been run. But nothing actually happens.
The macros are VBscript Macros that I know work as I can run them in the editor and they work fine.
But Mach3 doesn't actually run them. I have copied them into every folder I can think of in case its a path issue. Still no go.
If I delete the macros Mach still says it ran the macro when I push the button.

I am lost. Any thoughts.

cheers and thanks

Pages: 1