5621
Mach4 General Discussion / Re: Spindle Controls
« on: December 26, 2017, 06:33:57 PM »
Hi,
that is my understanding. There is the 'true rpm DRO' but it just reflects the measurement and calculation made by observing the index pulse from the
spindle.
If you want to know why the Speed Rate Overide doesn't apply to the measured speed is because Mach4 is NOT a closed loop controller.
Craig
that is my understanding. There is the 'true rpm DRO' but it just reflects the measurement and calculation made by observing the index pulse from the
spindle.
If you want to know why the Speed Rate Overide doesn't apply to the measured speed is because Mach4 is NOT a closed loop controller.
Craig