5431
Mach4 General Discussion / Re: Mach4 Button OFFLINE
« on: February 01, 2018, 03:05:01 AM »
Hi,
that looks right. Just try scanning the complete Output Signals page just to make sure that no other output signal has been attached to the
same pin.
Also would you copy and post one of the macros, m210 say. Mainly to check that I have programmed it right, although it works here.
Craig
that looks right. Just try scanning the complete Output Signals page just to make sure that no other output signal has been attached to the
same pin.
Also would you copy and post one of the macros, m210 say. Mainly to check that I have programmed it right, although it works here.
Craig