4501
Mach4 General Discussion / Re: Vista CNC P1A-S with Mach4 - Problem
« on: May 22, 2018, 11:18:25 PM »
Hi Mauri,
I have used VistaCNCs P1A with Mach4 without undue difficulty, it was a bit troublesome
to get it set up as I recall but has been good since.
I have heard that the P1A-S is more troublesome, the LCD display?
If you could get it to work but minus the LCD display would that be adequate?
Craig
I have used VistaCNCs P1A with Mach4 without undue difficulty, it was a bit troublesome
to get it set up as I recall but has been good since.
I have heard that the P1A-S is more troublesome, the LCD display?
If you could get it to work but minus the LCD display would that be adequate?
Craig