1881
Mach4 General Discussion / Re: Mach 4 liniar automatic tool change
« on: December 11, 2019, 05:51:05 PM »
Hi,
yep....me too!
It would be even more intriguing if there were motion controllers that had 16 synchronized motors as smurph has suggested.
Then you could have an override axis from one motion planner operating on top of an axis nominally controlled by another planner...
the possibillites are endless.
The potential for Mach4 to get into highly complex production machines is good, not only with Mach4Expert but Mach4Ethercat.
I hope NFS succeeds in breaking into those markets, we as hobbyists are likely to ride on those coat-tails.
Craig.
yep....me too!
It would be even more intriguing if there were motion controllers that had 16 synchronized motors as smurph has suggested.
Then you could have an override axis from one motion planner operating on top of an axis nominally controlled by another planner...
the possibillites are endless.
The potential for Mach4 to get into highly complex production machines is good, not only with Mach4Expert but Mach4Ethercat.
I hope NFS succeeds in breaking into those markets, we as hobbyists are likely to ride on those coat-tails.
Craig.