1
General Mach Discussion / Re: Tuning keling motors in Mach3
« on: May 12, 2007, 05:15:52 PM »
Thanks guys,
The CPU is a very capable AMD processor, I believe the clock speed is around 2.2ghz. The computer is very minimalist with only Mach3 and Vcarve installed. lat night I got the motors turning but they were still slow, jerky, and skipping steps. Any more ideas?
The CPU is a very capable AMD processor, I believe the clock speed is around 2.2ghz. The computer is very minimalist with only Mach3 and Vcarve installed. lat night I got the motors turning but they were still slow, jerky, and skipping steps. Any more ideas?