Messages

21

Show"N"Tell ( What you have made with your CNC machine.) / Turret Tool Post

« on: May 11, 2009, 02:47:45 PM »

Hello All,
   Here is my new turret tool post. The turret has a spring loaded locking pin to align the tool station. Each station can be individually adjusted.

 The "T" slots were cut with a home made cutter, made from a 3/8" drill.

 The "T" nuts were mad 3 at a time and separated with a slitting saw.

 

22

General Mach Discussion / Pull-up Resistors

« on: July 22, 2007, 10:51:56 PM »

Hello,
Can someone please direct me to information on pull up resistors?

Thank you,

Ken

23

General Mach Discussion / Re: Mach3 Compatibility

« on: July 19, 2007, 04:31:28 PM »

Thanks man!

Ken

24

General Mach Discussion / Mach3 Compatibility

« on: July 19, 2007, 12:01:29 PM »

Hello,

Are Mach3, LazyCam, and the other software from Art Soft compatible with an AMD system?

Ken

25

G-Code, CAD, and CAM discussions / Interpolating holes

« on: June 03, 2007, 02:00:13 PM »

Hello,
   I would like to know if any one has experience with this problem? I am using MasterCam9.1, with the MasterCam/Mach3 post processor. I am interpolating some holes, but my machine will only make the arch on and off move. I have the holes programmed for center point with a 25% arch on and off, and I have selected enter and exit point setting. In verify, and back plot, everything looks good.

Ken

26

Forum suggestions and report forum problems. / E-stop error??

« on: May 06, 2007, 09:32:10 PM »

Hello all,

I am getting an e-stop error as if a switch was activated. There is no pattern to this, it even happens when the machine is just sitting there. I have checked each switch in the diagnostic screen, and raised the debounce from 2000 to 3000. 
Any thoughts???

Ken